Scanning the whole book
One button scans every chapter in order and saves what it finds to your Compendium. The scan keeps going if you close the window.
Steps
- Scan whole book is meant for a book in final-draft form. If you are still actively editing, you may want to wait: a chapter you change after it is scanned counts as unscanned and would be scanned again. Chapters do not have to be locked. In the Project hierarchy at the top of the Chapters tab in the left sidebar, press the Scan whole book icon on your book's row.

- The window opens with your book's title under its name. First it says "Pricing this book…". Then you see how many chapters are still to scan, and how many are already scanned (they won't be scanned again). Front and back matter is left out and the window says how many pages. If earlier scans are waiting for your review, the start button stays off until you deal with them: press Review it, or Review the first one, to open the first waiting chapter.

- Choose the two options if you want them. "Also accept findings StoryClerk could not confirm against your text" saves those as accepted instead of pending. Both options can stay off.

- "Also combine entries that are clearly the same" merges only strong matches, and each is listed with Undo.

- Tap the question mark to see roughly what the scan uses; only what is actually used counts. If you have too few credits, a message says so with a way to get more, and the scan does not begin. The button at the bottom reads "Scan whole book" (or "Scan whole book again" when you are continuing); press it and the scan runs. Once running, progress shows at the top of the window: "Scanning chapter 3 of 12 — 9 left to scan. You can close this window; it keeps going." Each chapter row moves from Waiting to Scanning… to Saved, and a line such as "credits used so far" tracks what has been used. Stop after this chapter ends the run cleanly after the chapter in progress; chapters already saved stay saved, and you continue later with Scan whole book again. When it finishes you get a summary: per chapter, how many facts were accepted or are pending your review, new entries, entries combined, possible duplicates and Iceberg insights, plus the total credits used. Anything left pending or listed as a possible duplicate is yours to decide: review it with the guide titled Review scan results.

Questions
- Where is the button?
- The Scan whole book icon on your book's row in the Project hierarchy at the top of the Chapters tab in the left sidebar. It needs a book open.
- What does it use?
- The question mark in the window shows roughly what your book uses, from the chapters still to scan. Chapters already scanned and unchanged are skipped and aren't counted again. Only what's used counts.
- Can I keep writing while it runs?
- Yes. It runs on our servers, so you can close the window or the whole tab. Be aware that a chapter you edit after it has been scanned counts as unscanned.
- What if a chapter fails?
- The run stops there, because each chapter builds on the ones before it. If it stops or is interrupted, a card in the corner says so, with Open it to continue. Chapters already saved stay saved, and Scan whole book again picks up the rest.
- Should I use this or scan chapter by chapter?
- Chapter by chapter lets you review each result as it arrives. Scan whole book is quicker for a finished book. See Scanning one chapter for lore for the first.